Does Your Tesla Even Have Fog Lights?
It's one of the most inconsistent parts of the Tesla lineup — some cars have them, some never did, and some lost them in a refresh. Here's exactly how to check yours, plus fixes and upgrade options.
Quick Summary
Fog light fitment on Tesla varies by model, year, and trim — not just model. This guide shows you how to confirm what your specific car has, why so many 2019–2023 Model 3/Y units don't have them, and what to do whether yours is broken, missing, or you just want to upgrade it.
Model S and Model X have had front fog lights standard since the 2016 refresh. Model 3 and Model Y are the confusing ones: many Standard Range/SR+ cars built from 2019 onward shipped without them, and the 2023+ Highland/Juniper redesign removed the fog light position altogether.
Does My Tesla Have Fog Lights?
Unlike most of Tesla's lighting, fog light fitment isn't consistent across a model line — it comes down to trim, build date, and sometimes market. The fastest way to check is on your own car.
- Open Controls > Lights on the touchscreen.
- Look for a dedicated fog light icon or toggle.
- If it's there, your car has functional fog lights. If it isn't, either your car was built without the hardware, or (rare) it has the housing but not the wiring enabled.
Visual check as a backup: pop the small cover at each front bumper corner — a plain black plastic blank means no fog light was installed; an actual lens with a bulb or LED board behind it means the hardware is there, even if the touchscreen doesn't show a control for it.
Model S & Model X: Fog Lights Since the 2016 Refresh
Model S and Model X have had front fog lights as standard equipment since the April 2016 refresh, and they've stayed part of the design through the current Plaid-era cars. On US-market vehicles they typically show up as an amber "Up-Level" style unit at each front bumper corner, controllable from the same Controls > Lights menu as the rest of your exterior lighting.
If yours has stopped working, it's almost always a unit-level fault rather than a fitment question — see the troubleshooting section below.
Model 3 & Model Y: It's Complicated
If you're searching "does my Tesla have fog lights" because your 2019–2023 Model 3 or Model Y doesn't, you're not imagining it — Tesla changed fitment more than once on these two models.
2017–2019 cars
Early Model 3 and Model Y builds generally shipped with functional front fog lights across trims.
2019–2023 cars (the confusing years)
Starting around 2019, Tesla began building Standard Range and SR+ trims without functional fog lights as a cost-reduction measure — the bumper corner got a plain plastic cover instead of a working lamp. This is the generation most owners mean when they ask about "2021 Tesla fog lights": the hardware and wiring point were frequently still there under the bumper, but the lamp itself, and the touchscreen control, were not.
Highland (Model 3, 2023+) & Juniper (Model Y)
The Highland and Juniper redesigns moved to a new front bumper with a slimmer headlight and no front fog light position at all — it's not a decontented trim issue anymore, the housing simply doesn't exist on the newer bumper design.
Bottom line: if your Model 3/Y doesn't have fog lights, check your build date and trim before assuming something is broken. In many cases, it was never equipped in the first place.
DOT/E-Mark Certified · Plug & Play
Front Bumper Fog Light Replacement for Model 3/Y
Direct-fit replacement for a broken or missing factory fog light — precision-matched to the OEM housing and connector.
Troubleshooting: Fog Light Not Working
If your car does have factory fog lights and one has stopped working, work through these before ordering a replacement:
- Only one side out: almost always the unit itself — a failed LED board or a bad connector — since each side runs its own circuit.
- Dim or flickering: check for moisture inside the lens; a foggy or wet-looking housing points to a failing seal.
- Both sides out at once: more likely a shared fuse, a software setting, or a harness issue near the bumper connector than two simultaneous unit failures.
- Cracked or yellowed lens: cosmetic on its own, but a crack lets moisture in over time and usually leads to a full failure eventually.
For headlight-specific issues like fogging or aim, see our headlight fogging & water guide — the same moisture-intrusion logic applies to fog light housings.
Retrofit & Upgrade Options
If your Model 3/Y never came with fog lights, you have two realistic paths:
Retrofit a factory-style fog light
On pre-Highland/Juniper cars, aftermarket kits are available that fit the existing bumper cutout and connector. Because the touchscreen won't display a fog light control unless the car recognizes the hardware, most kits wire the new light to activate with the DRL or low beams instead of a dedicated switch — worth confirming before you buy if you specifically want manual on/off control.
Upgrade an existing fog light
If yours already works but you want more visual presence, upgraded units — including RGB and sequential-turn-signal styles — are available as direct swaps.
Highland/Juniper owners: since the newer bumper design has no fog light cutout at all, retrofitting isn't a bolt-on option — any solution would require bumper modification, which isn't something we'd recommend for a functional light that most drivers rarely use anyway.
Frequently Asked Questions
Does my Tesla have fog lights?
It depends on your model, year, and trim. Model S and Model X have come with front fog lights standard since the 2016 refresh. Model 3 and Model Y are inconsistent: base/SR+ trims built after 2019 typically shipped without them, and the Highland (Model 3, 2023+) and Juniper (Model Y) refreshes removed the front fog light position entirely. Check Controls > Lights on your touchscreen — if there's no fog light icon, your car doesn't have them.
Why doesn't my 2021 Tesla Model 3 have fog lights?
Starting around 2019, Tesla began building Standard Range/SR+ Model 3 units without functional fog lights, leaving a plain plastic cover in that bumper position instead. This continued through 2021 and later on lower trims, even though the wiring and mounting point were often still present underneath.
Can I add fog lights to a Tesla that didn't come with them?
Yes, on Model 3/Y built before the Highland/Juniper refresh. Aftermarket fog light assemblies are available that plug into the existing harness or splice into the DRL/turn signal circuit. Since the touchscreen won't show a fog light control unless the car recognizes the hardware, most retrofit kits wire the light to come on with the DRL or low beams instead of a dedicated switch.
Why is only one of my Tesla's fog lights working?
A single-side failure is almost always the fog light unit itself — a failed LED board, a cracked lens letting in moisture, or a loose bumper-side connector — rather than a shared fuse or software setting, since both sides run on independent circuits.
What you've learned in this guide
A quick recap before you check your own car.
Fitment isn't just by model
Trim, build date, and refresh generation all matter — two Model 3s from different years can be completely different here.
S & X have had them since 2016
If yours is missing or dark, it's a fault, not a fitment gap — go straight to troubleshooting.
2019–2023 Model 3/Y is the gray zone
SR+ trims often skipped fog lights entirely — check Controls > Lights before assuming yours is broken.
Highland/Juniper removed them
On the newest bumper design, there's no fog light position to retrofit into.
- Fast Local Shipping (US & EU)
- 1‑Year Warranty
- Verified Fit by Model
- Free VIN Confirmation
